I have to write firmware to a box with an IBM STB 02500 controller, I lost the software to write the image and I'd like to develop my own program to flash the chip.
I have knowledge on C# and serial programming but I had not developed any program like this so any advice on the first steps are welcome, e.g. let's say I have the image file and I can get connected to the box, what are the commands and how I should execute them to write the image properly.
Ps. This is the chip's datasheet, https://www-01.ibm.com/chips/techlib/techlib.nsf/techdocs/C915A9928B49DAA487256BC2003813EF/$file/STBx25xxFINAL.PDF
own flasher programserial port programming
Geen reacties in dit onderwerp
1 gebruiker(s) lezen dit onderwerp
0 leden, 1 bezoekers, 0 anonieme gebruikers